DISH receiver AUX input SAT TV 4 Press the SAT button on the side of the remote control 3 Open the front panel of your DISH receiver, and press the SYS INFO button SYS INFO 2 Replace the back cover PULL 1 Remove the back cover by pushing the latch upward, and remove the PULL tab Turn On Your RemoteFile Size: 1MB. · Remote Control Model Turn On Your Remote. 1. Remove the back cover by pushing the latch upward, and remove the PULL tab.. 2. Replace the back cover. 3. Open the front panel of your DISH receiver, and press the SYS INFO button.. 4. DISH Network Remote Control Manuals and Code Lists Dish Voice Command Remote Control for Hopper User's Manual/Guide DISH Network Hopper/Joey Universal Satellite TV Remote Control Manual Dish Network IR UHF Remote Control Universal The Original OEM remote you receive will be the one pictured unless part of a multiple qu.
In addition, the DISH Network EZ Remote Control lets you switch between satellite receiver programming and programming from an off-air antenna with the press of one button. B UTTONS AND F EATURES O VERVIEW. Figure 1 on page iv briefly describes each button on the DISH Network EZ Remote Control. DISH receiver AUX input SAT TV 4 Press the SAT button on the side of the remote control 3 Open the front panel of your DISH receiver, and press the SYS INFO button SYS INFO 2 Replace the back cover PULL 1 Remove the back cover by pushing the latch upward, and remove the PULL tab Turn On Your Remote. 3. Point the remote at the product and hold the correct button. This button will depend on what you're trying to program the remote for: TV — Press and hold the TV button at the top of the remote. Anything else — Press and hold either the AUX button (all products) or the DVD button (DVD players and VCRs).
Page 24 Learning from Another Device’s Remote, continued To have the DISH Network remote control learn specific commands for another device, complete the following steps. Ensure the DISH Network remote control is working with the receiver (see page 4). Place both the DISH Network remote and the original device’s remote control on a flat. Dish Network User Manual (46 pages) Dish Networks Remote Control User's Guides. Brand: Dish Network | Category: Remote Control | Size: MB. Table of Contents. 2. Pull the remote battery cover off. Decide whether to use IR or UHF signals for the remote. Use UHF signals if you do not have a clear line of sight between the remote and the receiver. Set UHF/IR SWITCH to either UHF or IR. If your remote has a blank, black key, continue to Insert the Batteries on page 2. If your remote shows a “1” or a.
0コメント